PACKAGING

In plastic cartridges of 280 ml, 300ml, 310ml

COLOURS  

White. Black or on request.

PHYSICAL PROPERTIES

-          Primerless adhesion to most common substrates of the building sector.

-          Elastic performance

-          Good weatherability

-          Low odor

-          Good tooling characteristics

-          Non-corrosive to metals

-          Suitable for alkaline substrates such as concrete, mortar, fibrous concrete.

 TECHNICAL PROPERTIES

1. Application temperature                                         -20 to +40 oC

2. Extrusion rate at 23^oC, 3-mm nozzle,                  9 ml/s

pressure 0,63 N/mm²

3. Skin-forming time at 23^oC/50% rel. humidity :          25' - 40'              

4. Vulcanization rate at 23°C / 50% r.h. :                  1,0 mm/day

5. Hardness, SHORE A:                                           22±2     

6. Temperature resistance :                                                 -40 to +100 oC

7. Joint movement capability :                                                          20%

8. Adhesion and extension test according to DIN EN 28339 :

(The test results were taken from the laboratory extensionmeter ASTMC 920-01).

Substrate :  luminium

σ100 N/mm2	σmax N/mm2	longation at break  (%)
0,32	0,5	400

Accuracy : ± 5%

RESULT : Excellent Adhesion

KALI 2000 silicone is suitable for sealing and joining constructions of glass, aluminium, Tiles(Mardura Gold), ceramics, glazed Tiles(Mardura Gold), metals (zinc, copper, etc.), plastics (PVC, epoxides, polyester, polyacrylate, formica, etc.), varnished or painted wood, etc.

KALI 2000 IS ESPECIALLY SUITABLE FOR SEALING JOINTS ON POWDER COATED ALUMINIUM FRAMES, ON THE EXTERNAL SIDE OF THE FRAME BETWEEN THE ALUMINIUM AND THE MARBLE.

INSTRUCTIONS FOR USE

CARTRIDGES

The closed cartridge is cut at the point where the thread ends. Then the nozzle is screwed on the cartridge and cut (slantwise preferably) to form an opening proportional to the joint width. After the cartridge has been cut appropriately, the sealant is applied in the joint with the use of a hand- or air-gun.

The sealant must be applied on clean and dry surfaces (without any dust, loose particles, oil, etc.).

The use of self-sticking paper tape (MASKING TAPE) on both sides of the joint is recommended, in order to avoid soiling.

Immediately after the application of the sealing material in the joint, the surface of the uncured sealant is smoothed with the use of a spatula or by finger.

Restrictions : The width of the joint must be neither less than 3-4 mm, nor more than 30-40 mm.

Precautions : Contact with eyes must be completely avoided. In such case wash with plenty of water. Keep it away from children.

Storage stability : at least 12 months if stored in a cool (below 25^oC) and dry place.